Painless Leg Hair Waxing

{YBA} Leg waxing is a painful process but the goal of smooth waxed legs can be achieved by following simple steps. I am writing this article to achieve the target of painless leg hair waxing.

Step 1

Start heating up your wax while you are on step 2.

Step 2

Please do this step and step 1 side by side. After you plug in your wax,

  1. Soak your legs in a bath of warm to hot water.
  2. Ideal duration of leg soaking is 18 to 20 minutes.

Why not listen your favorite music on iPod, or read a good story book during this long step.

Step 3

Time to turn of your music or story book chapter. I hope your wax is liquefied now.

  1. Dry off your legs.
  2. Apply 1-2 inch strip of wax on your leg with your applicator.
  3. Wax application should be even and not to let it drip.
  4. Cover the wax with a linen stirp.
  5. Rub the strip in one direction so that the wax soaks deep into the strip.

Step 4

Once the linen strip has been saturated by the wax on your leg.

  1. Hold down the skin just below where the end of the linen strip is, and using your other hand rip the strip off in the opposite direction as your hair growth.
  2. Do this in a fast motion staying as parallel to the leg as possible.
  3. Continue this routine until all of your leg area is hair free.

Don’t forget to comment on this post, as their is always a door of perfection and knowledge.

You may also like...